Standard use can prolong the service life of welding rotator and avoid accidents. Before use, check whether the external environment meets the requirements without interference of foreign matters; There is no abnormal noise, vibration and smell during the power on air operation; Check whether the bolts at the mechanical joints are loose. If they are loose, fasten them before use; Check whether there are sundries on the guide rail of the formation machine, whether the hydraulic system operates normally, and whether the roller rotates normally.

When using, after the workpiece is hoisted on the welding rotator, first observe whether the position is appropriate, whether the workpiece is close to the roller, whether there are foreign matters on the workpiece that hinder the rotation, and confirm that everything is normal before the formal operation. Turn on the power switch, start the roller to rotate and adjust to the appropriate speed. When it is necessary to change the rotation direction of the workpiece, press the reverse button after the motor stops completely. Before welding, idle the cylinder for one circle, and determine whether the cylinder position needs to be adjusted again according to its moving distance. During welding operation, the ground wire of welding machine cannot be directly connected to the roller frame to avoid damage to the bearing. Contact with fire source and corrosive substances is strictly prohibited on the outer surface of rubber wheel. The roller frame of the team shall check whether the oil level in the hydraulic tank is normal regularly, and the sliding surface of the track shall be kept lubricated without foreign matters.

For the maintenance of the welding rotator, the gearbox should be filled to the center line of the oil mark before use. During operation, the oil level should be observed frequently and the lubricating oil of the same brand should be supplemented in time. The lubricating oil and grease should be changed regularly. Generally, the first change is to run for 300 hours. The residual dirty oil should be removed during the change, and then it should be changed every 6 months. If it has not been used for a long time, replace the lubricating oil and grease when it is restarted. Generally, l-ckc68 ~ CKC150 extreme pressure industrial gear oil or better lubricating oil shall be selected as lubricating grease, which shall be inspected and cleaned before welding.

MISA WELDING(WUXI)Co;Ltd has been commited to the development and production of welding products,and now the products have been sold all over the world. Welding and positioning equipment is suitable for many fields. Such as oceanic engineering, pressure vessel, pipe manufacturing, wind power fabrication and so on.